Description
This tee is used where termination is exposed to heavy wind, rain or prone to freezing. Made from UV-stabilized polypropylene, designed for use with 3″ Innoflue SW (Single Wall) pipe and fittings. For best performance, use in combination with bird screen(s) (part# IASPP03). Overall length is 29.2″
Features:
- Innoflue SW (Single Wall) is the only polymer vent system on the market listed to UL 1738
- Accepted and approved by over 50 North Amercian manufacturers of boilers, water heaters and furnaces
- Suitable for natural gas, propane and fuel-oil condensing and non-condensing (flue temp. below 248°F) appliances
- All parts (pipe, fittings, etc. – both black and grey) are UV resistant and suitable for indoor or outdoor installation
- Requires no primer/glue and does not leach chloride like PVC & CPVC
- Costs less and is faster and easier to install than stainless steel venting, no special tools needed, zero clearance to combustibles
- Industry-leading 2mm wall thickness
- Built-in gasket allows for adhesive-free installation which can be adjusted at any time
- May be installed through a wall, chimney, chase or between joists
- Lightweight, requires minimal support
- Made in the USA from environmentally-friendly PolyPropylene (PP).
Reviews
There are no reviews yet.